The RP2 2.4GHz ELRS nano series receivers is an open-source receiver based on ExpressLRS.

The Nano receivers, first developed by Jye Smith from the ExpressLRS development team, feature ESP8285 MCU and SX1280 RF chip. The RP1 has a UFL antenna socket for full-range antenna use.

The RP1 and RP2 feature WIFI built in so you can upgrade firmware by WIFI and configure the Receiver via the built-in WebUI with your PC or mobile phone.

Due to the low-latency and high-refresh-rate RF module, the RP1 and RP2 are ideal for FPV races or Long Range. Suitable for Whoops, drones, and fixed-wing models due to the ultra-light and Nano size, these receivers can fit just about anywhere!

Features:

• Improved PCB design is better for heat dissipation.

• LED on the top side of PCB.

• Solder pads are improved and easier to solder to.

Specifications:

• Item: RP2 Nano ExpressLRS 2.4ghz Receiver

• Type: ISM

• Antenna: On Board SMT Antenna

• Maximum receive refresh rate: 500Hz/F1000Hz

• Minimum receiver refresh rate: 25Hz Working voltage: 5v

• Weight: 0.55g (On Board antenna)

• Dimension: 13mm*11mm*7mm

• Firmware Version: ExpressLRS v2.4 pre-installed

• FW Target: RadioMaster RP1/2 2400 RX

• Bus interface: CRSF